A brand-new kitchen: the checks before your first serious cook
Published on 20 November 2026

A new kitchen is handed over looking its best and judged at its worst within days. The first family meal you actually cook tests more surfaces at once than any walkthrough the installer could stage: hot pans, splashing water, full drawers and the extractor running. It is worth deciding, before that meal, which things you want to have proven — because a check done after the first disaster reads like blame, and a check done before it reads like normal handover.
Find the stopcocks and switches before you need them
Every kitchen has shut-offs: the stopcock or isolation valve for the sink mixer, usually inside the base cabinet, and the individual spurs behind the oven, hob and dishwasher. Open each cabinet door and confirm you can physically reach each valve without uninstalling anything. Then switch the appliance spurs on and off once, so you know which switch does what. The morning a pipe weeps is the worst possible time to be learning this for the first time.
Let the water prove itself twice
Fill the sink and release it: watch the siphon and the waste connections with a torch, and feel the cabinet base for damp when it has drained. Then run the mixer on hot and cold separately and time how long hot water takes — a long wait is normal in some layouts, but it is good to know now rather than to suspect a fault later. If the dishwasher is installed, run one short hot cycle empty before the first loaded one, and check nothing pools under the door seal.
Test extraction the way cooking tests it
A cooker hood either ducts outside or recirculates through filters, and the two fail differently. Hold a sheet of paper near the filter while the hood runs on its highest setting: if it is captured, airflow is working. For ducted systems, feel for air actually arriving outside. Recirculating hoods need their filters registered as consumables in your paperwork, because they silently stop doing their job when saturated. Which setup you have is a fair question to ask in writing during handover.
Worktops, joints and the things that still need to cure
Silicone beads between worktop and splashback look finished the day they are applied but need time to cure fully; ask how long before standing water at the seam is safe. Solid wood worktops have their own rule set: they are usually oiled or lacquered to a specification, and the first hot pan left on the wrong finish teaches the lesson expensively. Ask, before the first cook, what the surface is actually finished with and what the manufacturer says about heat and water at the seams.
Load the cabinets the way real cooking will
Empty doors hang straight; full ones reveal everything. Put weight in the drawers you will really use — pans in one, plates in another — and open and close each one twice. Look at hinge fixings, check that doors still shut to the same gap, and listen for new sounds. A door that aligns empty and sags loaded is a small adjustment at the hinge screws, not a warranty crisis — but it is a conversation you want to have while the fitter can still be booked cheaply.
One dated page, taken while everything is still new
Photograph the appliance rating plates, the stopcock locations and the worktop finish note, and write one page dated the day you got the keys: what works, what you were told, what still feels unresolved. If a fault appears in the first months, that page turns “something is wrong” into a sentence with a date, a location and a photo attached — which is how ordinary corrections get made without arguments.
None of this is a certification. It is simply the difference between a kitchen you admire for a week and a kitchen you trust through the first winter of real cooking.

